Can someone tell me my bolt pattern?

[Max_118]

Can someone please tell me the bolt pattern for my wheels? I don't have the tool to measure them; nor do I have a manual. My car is a '74 Duster. The wheels are 14". (I have no idea why the previous owner had the washers on there)

 

[krazykuda]

Those should be 4 1/2" bolt pattern...

Single caliper disc...

 

[halifaxhops]

Looks like 5x4.5. Just measure it. Easy to do.

 

[doug 371]

4.5 maybe he was using them as a wheel spacer...

 

[Ahoey]

My 74 dart has 4.5 in stud circle very common on that era of mopar

 

[A56]

This

 

[Max_118]

Thanks for the non help. I do know how rulers work, but I didn't know where to measure from. Someone else was kind enough to tell me something useful. But thanks for playing!

 

[66fyssh]

Welcome to FABO!!

People like to play...sorta like hanging out in the garage and razzing each other.

That era was mostly 5 on 4.5". Certainly someone could have swapped in a different rear. Tolerances were a little loose back then and rears can be off by as much as three quarters of an inch. Like @doug 371 said, probably used washers as a spacer.

 

[Ahoey]

5 studs on a 4.5 inch diameter circle only so many places you can put 5 studs evenly on a 4.5 inch circle pay attention to centre hole for axle those very a lot. Have fun and the razz like water off a ducks back LOL.

 

[A56]

Thanks for the non help. I do know how rulers work, but I didn't know where to measure from. Someone else was kind enough to tell me something useful. But thanks for playing!

just showing you the "special tool" that you don't have