Colo kid

-
All of that depends on the wheel offset.
I have a set of Weld 15 x 12 wide with 7 inches inset toward the inside.
 
Sorry, i was just talking about the wheel offset being a concern when doing what you are asking.
The wheels are not on a car.
 
Stephen Mulkey said:
Sorry, i was just talking about the wheel offset being a concern when doing what you are asking.
The wheels are not on a car.
Click to expand...
Just need some feedback if it is possible, I heard they tried using 12” rims on the 1969-1970 supertock cars/ for wider slicks
 
Is this what you are asking about?
To get those wheels and tires under there is quite a bit of modified metal. Anything is possible given enough money. But it sure looks good.
01-1517867396278@2x.jpg
 
Had 15x12 on my old Dart, mini tub to the frame. Set your rear end then measure for your wheels, mine had 4 inch back space.

4F9D7570-88FC-48C0-8CC1-9E23C83C78F9.jpeg
 
jaws said:
12-30-15
Click to expand...
I’m trying to run 16.5 X 31 X 15 / wheels 15 X 12 with 4.5 backspacing with Calvert +1” lift leaf springs, Calvert rear sliders, Calvert traction bars. I plan to cut the quarter panels like the old super stock Hemi cars
 
14 wide is pretty much max for a 12 inch wheel. 16.5 is a big tire, might want to look into a 14 wide wheel.
 
Update ,ended up ordering 315/60/15R Mickey Thompson R series Radials because of the side wall flex on a 10” rim/ 4.25 BS no tubes
 
You must log in or register to reply here.
-

Back
Top