Tsully
Well-Known Member
Used Hydraulic Flat Tappet Comp Cam and Lifters for a 383-440.
I was told by the guy that they ran it in a dyno engine and then we’re taken out after break-in. The lifters are boxed in order for each cylinder.
It’s a Comp Cam 21-228-4 Kit
Here’s the link to Comps site for the specs:
21-228-4(Single Bolt) - Xtreme Energy™ Hi-lift Hydraulic Flat Tappet Camshafts
Got this as part of deal when I recently purchased some heads and Intake, so I really know nothing about it other than what I’ve been told by the previous owner.
Asking $100 OBRO plus shipping to lower 48.
I’m located in St George SC 29477 right outside of Charleston if you want pick it up locally.
Any questions just ask!
As always....Thanks for looking!
View attachment 1715240363
I was told by the guy that they ran it in a dyno engine and then we’re taken out after break-in. The lifters are boxed in order for each cylinder.
It’s a Comp Cam 21-228-4 Kit
Here’s the link to Comps site for the specs:
21-228-4(Single Bolt) - Xtreme Energy™ Hi-lift Hydraulic Flat Tappet Camshafts
Got this as part of deal when I recently purchased some heads and Intake, so I really know nothing about it other than what I’ve been told by the previous owner.
Asking $100 OBRO plus shipping to lower 48.
I’m located in St George SC 29477 right outside of Charleston if you want pick it up locally.
Any questions just ask!
As always....Thanks for looking!
Last edited:
