[WANTED] Connectors and wire for splicing

[spinman_1949]

The wiring to the altenator and the temp sender unit is frayed and brittle on the 69 Dart GTS. I can splice in back near the firewall, but I need good condition wire and connectors for about 2 to 3 feet. No luck on web, so I figure possibly scrap harness is only option. Total of 3 with connections. Two to alternator and one to the temp sender. One of the two to the alternator is I am guessing 10 guage.

Thx

Spinman

 

[Dubob]

I can think of a couple of options here that may help if you wanna go new. You could replace the whole engine harness. Or call Evans wiring and see if they would just make you the runs you need, they also sell complete harnesses. I bought my engine harness from them for the big block with electronic ignition going in my Demon for 115$. If they will sell just the separate runs you need just de-pin the connector at the firewall and install the new.