Cruise control

[Twodko]

Does anyone have a picture of the Cruise control
mechanism with the two cables coming out
of it that connect to the carb? I want to see where
this is mounted under the hood.
My '72 has CC and this thing is mounted
on the drivers side inner fender between
the batt and MC.
I think the CC in my car was a dealer install
because there is no fender tag code for it. Thanks

Tom

 

[DDodger]

might not even be Mopar. there were several aftermarket systems, over the years

some even had factory appearing turn sig levers. division of spicer used to, don't remember the name

 

[mcodecuda]

The Cruise control option will appear on the build sheet. It won't be listed on the fender tag.

 

[mderoy340]

look in section 8 FSM

 

[Twodko]

Indeed mine does look factory installed right down to the
factory turn signal lever with the CC slide switch etc..
I didn't knowing the CC code only appears on the build sheet,
thanks for that. I'm headed for my FSM after I post this.

I'm having a hard time getting the back seat cushion
unhooked to see if there is a build sheet in it.
Its so tight back there I can't seem to be able to get enough leverage
to push the cushion back far enough to clear the hooks.

Its always something.

 

[Pawned]

Indeed mine does look factory installed right down to the
factory turn signal lever with the CC slide switch etc..
I didn't knowing the CC code only appears on the build sheet,
thanks for that. I'm headed for my FSM after I post this.

I'm having a hard time getting the back seat cushion
unhooked to see if there is a build sheet in it.
Its so tight back there I can't seem to be able to get enough leverage
to push the cushion back far enough to clear the hooks.

Its always something.

same problem with the back seat cushion, I have to take a small bottle jack and push it back with that. PITA