ir3333
Well-Known Member
for those who have curved their stock Mopar electronic distributor,what springs did you use and at what rpm was you're mechanical "all in"?
curving sm blk distributor
- Thread starter ir3333
- Start date
-
TrailBeast
AKA Mopars4us on Youtube
Mr. Gasket 925B and all in by 2,500 RPM
You can get them online though Autozone or Holley or other places for about 10 bucks.
You can get them online though Autozone or Holley or other places for about 10 bucks.
ir3333
Well-Known Member
just one Mr. Gasket 925B spring and the stock mopar light spring?
sounds about perfect!
sounds about perfect!
TrailBeast
AKA Mopars4us on Youtube
For an approximate 2,500, yes.
Might as well get the FBO timing limit plate J685S while you are in there anyway. (www.4secondsflat.com)
joshua dewitt
Well-Known Member
used the fbo limiting plate, fbo ignition box, and his spring kit, 18 degree slots, and 2 middle silver springs. all in around 2200-2500ish
340doc
Well-Known Member
I got the lightest spring I could find, stretched it out a bit so it pulls the weights back during start up. After that I'm all in at idle.
-
