Defroster vent hoses

[David273cars]

I need to replace the defroster vent tubes in my 1964, non air conditioned Barracuda. The old ones are brittle, torn, etc. I know yours had to be the same way.

Where did you get yours from.

The original vents in the dash, (which I'm using), where the hose attaches, are 2 1/2" outside diameter, one of the outlets on the heater box is 2" OD and the other is 2 1/4" OD. :wack:

I'm really trying to avoid the duct tape!

I know Ma Mopar is laughing somewhere!!

Thanks,
Dave

 

[65Vart]

I need to replace the defroster vent tubes in my 1964, non air conditioned Barracuda. The old ones are brittle, torn, etc. I know yours had to be the same way.

Where did you get yours from.

The original vents in the dash, (which I'm using), where the hose attaches, are 2 1/2" outside diameter, one of the outlets on the heater box is 2" OD and the other is 2 1/4" OD. :wack:

I'm really trying to avoid the duct tape!

I know Ma Mopar is laughing somewhere!!

Thanks,
Dave

I got mine from The local PartsSource, try Advance, UAP etc. They are not factory correct but they fit (plastic vent hose)

 

[Dfnsmn34]

try these guys. I bought for my 66 cuda. worked great. Had to use cable ties to "clamp" it though. but they fit good.


http://www.nostalgicairparts.com/ac/duct-hose-sold-by-the-foot-76.php


aloha

 

[OldVart]

I got the reinforced plastic type replacements from NAPA. As mentioned, use a wire tie or a hose clamp to suck it in tight on the 2" fitting.

 

[cudavert]

Somebody needs to make some foam "sleeves" for the ends.

 

[416stroker]

I have one factory NOS one for the 2 inch side.

 

[70Duster440]

As a followup to what Dfnsmn34 said, this is what I did...

http://www.forabodiesonly.com/mopar/showthread.php?t=73813&highlight=hose

 

[David273cars]

Thanks everybody!!

70Duster440....THANKS!! Ordered the set of 2", 2 1/2" and the adaptor.

Problem solved!