These are a pair of disc brake dust shields that are used on the 1973-76 A body cars and 73-74 Barracuda's and Challenger's.
These dust shields have the proper center opening for the larger inner wheel bearing that was used during those years.
A good dust shield to use when upgrading to the larger 11 3/4 inch rotor when doing a disc brake upgrade or changeover. I hand scrubbed, cleaned them up, in the solvent tank, and they cleaned up great. They weren't rusted pieces of junk to start out with.
The pair are galvanized metal, and the single one is aluminum.
The aluminum one has a slight crack, by one of the bolt hole locations.
I don't remember if it's a left side or right side shield.
This is the last pair of shields that i have in stock. All my others have now sold.
$45.00 for the pair of shields, $22.50 for the single aluminum one. Plus the mailman.
Figure i can mail them out in a USPS flat rate box at $17.20.
Serious buyers, send me a message, and we can go from there.
I will send my Pay Pal information over to you.
Thank's a lot.
Jim V.
hemi71x
These dust shields have the proper center opening for the larger inner wheel bearing that was used during those years.
A good dust shield to use when upgrading to the larger 11 3/4 inch rotor when doing a disc brake upgrade or changeover. I hand scrubbed, cleaned them up, in the solvent tank, and they cleaned up great. They weren't rusted pieces of junk to start out with.
The pair are galvanized metal, and the single one is aluminum.
The aluminum one has a slight crack, by one of the bolt hole locations.
I don't remember if it's a left side or right side shield.
This is the last pair of shields that i have in stock. All my others have now sold.
$45.00 for the pair of shields, $22.50 for the single aluminum one. Plus the mailman.
Figure i can mail them out in a USPS flat rate box at $17.20.
Serious buyers, send me a message, and we can go from there.
I will send my Pay Pal information over to you.
Thank's a lot.
Jim V.
hemi71x
