Distribution block reset??

[green72]

Ok I think I know what I did wrong now I need to know how to fix it. I installed a completely new brake system on my 72 Scamp KH power disks up front drums rear. When I tried to bleed the rear brake lines I pushed the pedal to hard and trip the switch in the new distribution block. I now can get fluid to the fronts but can't get fluid to the rears. How do I recenter the valve?

 

[Barracuda Bruce]

Bleed a little from the front. Should reset when pressure is equal.

 

[green1]

Open the front, and push pedal until you feel it click.

 

[green1]

Just read your earlier; keep opening each end, easy pedal, stop pedal movement at the click, hold it, tighten bleeder

 

[green72]

Thanks everyone I will give it a shot. Brake bleeding school didn't go so good today but I learned alot about the system!!