Drive shaft ball & trunnion upgrade

[eestatic]

Greetings FABO!
Finally getting around to upgrading my drive line & rear end change on my 65 Barracuda w/904.
I noticed that on various forums the parts listing for the upgrade have a
"Slip yoke 2-3-800kx" listed as one part needed but searching only shows a "2-3-8001kx".

Can anybody clarify if they are the same part?

From postings..

[Here are the Spicer part numbers
for the B&T conversion.
Flange 2-2-349
U-joint 5-153x
Slip yoke 2-3-800kx
Spline 2-40-1711
Tube 2 1/2 dia / .083 wall]

Thanks FABO!!
Dennis

 

[1963dartgt]

@slantsixdan should be able to point you in the right direction i think the slip yoke part number has changed.

 

[slantsixdan]

See here.

 

[eestatic]

See here.

Thanks for reply!

My concern is was when I searched for the "slip yoke #2-3-800kx" the closest number I come up with is [ 2-3-8001kx ]

 

[SmokinDuby]

See here.

I'm getting a download error when I click "here"

 

[Bad Sport]

I'm getting a download error when I click "here"

Try this.

http://www.earlycuda.org/techdocs/ConvertFrontUJoint.pdf