AdamR
Big Member
Anyone know the correct length for a 69 Barracuda with a 904 and 8-3/4" rear ?
Or how much shorter is a 904 then a 727 ?
Or how much shorter is a 904 then a 727 ?
Driveshaft length ?
- Thread starter AdamR
- Start date
-
I just went outside and measured mine Adam.
The 904 is 31 inch's and the 727 is 34 3/4 inches. Those measurements are within 1/4 inch as I didn't have the level with me to get exact measurements.
Remember the yoke is different to.
Jack
The 904 is 31 inch's and the 727 is 34 3/4 inches. Those measurements are within 1/4 inch as I didn't have the level with me to get exact measurements.
Remember the yoke is different to.
Jack
Johnny P
Active Member
you got them backwards. Because the 904 is shorter trans there for the driveshaft is going to be longer.
AdamR
Big Member
Coyote Jack said:
ThanksCJ. I know I need A yoke too.
hehe, look again. Those are the tranny lengths.
Jack
Jack
Adam, if you have a 727 yoke, I have a 904 yoke. We could trade.
Jack
Jack
AdamR
Big Member
We sure could. How soon do you need it ? I need to pick up a few more parts before I pull my 727.
No big rush here Adam. I won't be on the road until at least August.
Jack
Jack
AdamR
Big Member
Cool. I'll collect all the other parts then. If I end up with one sooner I'll still send the 727 one to you.
Sounds Good.
Jack
Jack
-
Similar threads
