Duster Bucket seat brackets

[Elís Máni]

I was just wondering i the a bodies had any special mounting brackets for bucket seats.
my 1973 Duster 340 was a factory bench seat car but has had bucket seats installed instaid and they were just bolted right through the floor with big spacers. is there any "corrcet" brackets i can get and install.
below you can see the floor in my duster and the holes where the seats bolt through.
Thanks!

 

[68 bee]

Yes they had 4 square plates welded to the floor by the transmission tunnel.

 

[Elís Máni]

Yes they had 4 square plates welded to the floor by the transmission tunnel.

But did they allways bolt right through the floor?

 

[gdrill]

The seats have sliding tracks that bolt directly through the floor pan........through those plates mentioned above.

 

[Elís Máni]

The seats have sliding tracks that bolt directly through the floor pan........through those plates mentioned above.

Allright thanks

 

[Keystone]

The plates mentioned are to reinforce the floor. The actual seat brackets look like this:

Not my seat/car by the way, just a picture I had on my computer. I'm planning on swapping out my bench seat too and I was curious what the OE brackets looked like as well.

 

[Garrett Ellison]

Summit and Jegs both carry the AMD seat brackets that were spot welded to the floors.
Auto Metal Direct 407-1067-S: Bucket Seat Floor Mounting Bracket Set for 1967-1976 Mopar A-Body | JEGS

 

[muddacres]

I thought I had a better picture. I hope this one helps.
Jim
Jim