Duster Emblems Clips

[superjarheadt]

Does anyone know where I can get the clips to hold the emblems just in front of the doors on the fenders for my 73 Duster?

 

[RPM]

ya that would be a good one to know... however I came up with a way to hold them on nice and tight if you cant find any. Go to the local hardware or farm store and get some kind of rubber tubing. Take your emblem in and match up some tubing that fits real snug over the prongs. Cut two pcs of the tubing place the emblem in the fender and press the tubing over the prongs on the back side... Holds the emblems on nice and tight and no fuss. It might be a cheap and cheezy way to do it.. but I have emblems on the car and never had to mess with them ;)


-RPM

 

[superjarheadt]

Yea Ive thought about doin that but I wanted to do it the proper way. Ive seen clips on ebay that look similar to factory but Im not sure on the size I'd need.
http://cgi.ebay.com/ebaymotors/Ford...3382204QQcmdZViewItem?_trksid=p4506.m20.l1116

 

[jjr426]

I just saw this post so you may have already found them but if not the Paddock sells them. They just slide over the prongs and you push them into the fender. Here is a link http://www.paddockparts.com/Paddock...alse&mscssid=0092E5B73219FB4F28953D574EDC48E1 I hope this helps Justin

 

[superjarheadt]

Thank you jjr426

 

[player1up]

I used sheet metal nuts... like the kind that the 73-73 tail light bezels use, just smaller