Duster fender badge correct location

[Paladin06]

Hello All,

I got a set of NOS "DUSTER" fender badges, with pins for CHERRY. Does anyone have documentation that shows the correct location of the holes I need to drill

Please advise.

 

[Rd8]

If they are original fenders they may have the
holes visible on the inside of the fender. If it was a gold duster or twister package then it was a decal and there would be no holes drilled.
Here's a picture of the right side. I can get you exact measurements if you need.

 

[Rengo]

I dont have the "Duster" on mine because it is a twister, but the pent star is 7 1/4 from the door forward and 6 1/2 up from the bottom of the finder. sorry if I was of no help.

 

[Paladin06]

I would appreciate it if you could provide the measurements.

Thanks

If they are original fenders they may have the
holes visible on the inside of the fender. If it was a gold duster or twister package then it was a decal and there would be no holes drilled.
Here's a picture of the right side. I can get you exact measurements if you need.

 

[ESP47]

Mine is a regular slant 6 71 Duster and has the decals, no holes.

 

[Rd8]

Measure 6.75" from the fender/door seam for horizontal
measure 3.5" down from the second contour line for the vertical.

This will give you direct center for the badge. Dip the pins in grease to mark and drill.

Hope that helps.