5150DodgeBro
Well-Known Member
I bought most of this stuff earlier this year, hoping to score a 68 GTS project that a guy had promised me. Well, so much for people keeping their word... Picked-up another project so I gotta let go...
Very early 1st year 340 bare block. Fully machined this past spring, .030 over with caps. Fully checked out, align bored and honed with deck plate, etc. Had one sleeve. Have receipt.
Cast 6/22/67 and I think it was assembled in September of 67...(It’s all wrapped up now) But has to be one of the very first 340’s to go into production. Super-find for someone looking to do a period correct GTS/Formula S. Core plugs and Cam bearings installed. No Crank, but have a friend who may part with one reasonably. Asking $2500
Pair of bare X Heads. 1968-71 P/N 2531894. These were checked-over by the machine shop, but only hot tanked. No valves or springs, but I have a pair of rocker shafts, adjustable arms and new adjustable screws. I believe I have a set of cup pushrods as well. Whatever I have for the heads can go with it. Asking $700
A-body 8 3/4 housing, complete and unaltered w/backing plates and original small bolt axles. I think I only have one brake drum. Asking $700
(Have a couple sets of gears available at add’l cost if you need a set)
Other misc:
2 sets of small bolt 14x5.5 wheels in nice shape
67-68 Dog dish caps, Dodge and Plymouth
Small block 727 core, flex plate(s)
7.25 rear shock plates
Pittsburgh, PA area 16063
Very early 1st year 340 bare block. Fully machined this past spring, .030 over with caps. Fully checked out, align bored and honed with deck plate, etc. Had one sleeve. Have receipt.
Cast 6/22/67 and I think it was assembled in September of 67...(It’s all wrapped up now) But has to be one of the very first 340’s to go into production. Super-find for someone looking to do a period correct GTS/Formula S. Core plugs and Cam bearings installed. No Crank, but have a friend who may part with one reasonably. Asking $2500
Pair of bare X Heads. 1968-71 P/N 2531894. These were checked-over by the machine shop, but only hot tanked. No valves or springs, but I have a pair of rocker shafts, adjustable arms and new adjustable screws. I believe I have a set of cup pushrods as well. Whatever I have for the heads can go with it. Asking $700
A-body 8 3/4 housing, complete and unaltered w/backing plates and original small bolt axles. I think I only have one brake drum. Asking $700
(Have a couple sets of gears available at add’l cost if you need a set)
Other misc:
2 sets of small bolt 14x5.5 wheels in nice shape
67-68 Dog dish caps, Dodge and Plymouth
Small block 727 core, flex plate(s)
7.25 rear shock plates
Pittsburgh, PA area 16063
Last edited:
