Edelbrock 440 RPMs

[roccodart440]

I dont plan to take them to a machinest unless someone tells me the reason why I need to take brand new heads to have them checked out?

Last set of heads that I had checked out cost me 50$ and needed a port sealed up that would have leaked antifreeze into my engine...

50$ is cheap for peace of mind.

 

[1930]

Thanks for all the comments, Im gonna pull the valves just to see what down there, Im gonna measure the valve guides and compare stems just for the experience, Im gonna re-assemble and maybe lap in the valves just to see what sort of a finish was left and make sure there is no chance of leaks, Im gonna get my gasket set and see how things fit just for the experience and knowing I know how things are gonna flow, If I see a possible problem Ill post some pictures.