Edelbrock BB RPM heads

[Mojoluv]

I have a set of Edelbrock BB RPM cylinder heads that I bought from a Moparts member and ended up not being able to use. I was told these heads had less than 25 runs on a mild engine that was in a dragster. He also said that they have one piece Ferrea valves and Comp 10* locks and retainers and springs. I was going to change the springs for a milder cam. He said that they did not port the heads due to the engine they used being in a lite dragster. I had a local race shop check them out and CC the chambers. They said the heads look great and have no wear, however they have been milled around .055 -.060 from their original 84cc down to 74cc so I cannot use them. I need an 84cc head. I will sell them for what I paid for them plus shipping. A little dirty but nice heads. $1400


part # 60929

 

[Mojoluv]

Price lowered...$1200 plus the ride.

 

[gremlin]

Were the intake flanges machined to match?

 

[sickandwrongcustoms]

i would love these just dont have the cash

 

[gremlin]

I have the money, just don't have any
response.

 

[Mojoluv]

Were the intake flanges machined to match?

Yes, the intake side was machined to match.

 

[gremlin]

Get me a total to 77088. PP or MO?

 

[Mojoluv]

Get me a total to 77088. PP or MO?

I'll try to have you a shipping quote tomorrow. PP as a gift only or MO. Either is fine with me.

 

[Mojoluv]

SOLD! Thanks Gremlin!