[SOLD] Edelbrock Dp4b 383-400. # 2

[Bigboy 68]

This intake has been cleaned and blasted it has three Healy coil‘s that were installed correctly it also has the Chrysler part number the tall coil tower had a boat that was drilled out this tower needs repair as they drove through the side of the tower an oblong the whole on top look at the pictures it should be an easy repair for someone who can weld aluminum
Asking 285+ shipping

 

[brian6pac]

What is the hole in the bottom of the heat crossover ?

 

[RustyRatRod]

That does not go through to the heat cross over. It's for the hot air choke. I have one exactly like it. They are all like that. Don't block it off, Bob. It's supposed to be like that. That's a good lookin intake. I bet something similar to JB Weld will fix it right up. That's a low torque bolt hole anyway.

Here's one just like mine and yours, Bob. Same hole top and bottom. They are made that way. Not tryin to keep crappin up your for sale thread man. I just want your potential customers to know there's no defect or anything wrong there.

 

[Bigboy 68]

Bump

 

[Bigboy 68]

275 plus shipping

 

[Bigboy 68]

Bump

 

[Bigboy 68]

265+ shipping

 

[Bigboy 68]

Bump

 

[Bigboy 68]

250+ shipping

 

[Bigboy 68]

Bump