360tripleblack7
Gold Member
Contact seller
Small Block Mopar Performer RPM Heads Stage 2 ported by Ryan Johnson from Shady Dell Speed Shop.
• Fully reviewed (Valve spring pressures, height install, valve lapping, valve guide clearance).
• 4 angles valve job
• 2.02" intake valves / 1.60" exhaust valves. Both with 30° back cut
• New Comp Cams Valve springs good for .630" Pressure at seat load [email protected]" / [email protected]"
• New Comp Cams 10° valve locks
• Flows over [email protected]" on intake side and [email protected]" on exhaust.
• All clean and ready to assemble on engine.
U$: 1900.00 + Shipping
Located in Tiffin - IA
• Fully reviewed (Valve spring pressures, height install, valve lapping, valve guide clearance).
• 4 angles valve job
• 2.02" intake valves / 1.60" exhaust valves. Both with 30° back cut
• New Comp Cams Valve springs good for .630" Pressure at seat load [email protected]" / [email protected]"
• New Comp Cams 10° valve locks
• Flows over [email protected]" on intake side and [email protected]" on exhaust.
• All clean and ready to assemble on engine.
U$: 1900.00 + Shipping
Located in Tiffin - IA