Rolling_Thunder
Rolling Thunder
Selling my cross ram intake - going a different route with my cars and will never use this thing.
The STR-15 was made by Edelbrock into the 70s and fit the low deck mopar big block engine (361/383/400) engine family.
Intake - all bolt holes appear good, no helicoils or oversize holes. The lid is the dual quad offet style. All surfaces seem clean and undamaged - no pitting or milling is apparent.
Carburetor linkage pivot is included -
Included: Intake base, Intake lid, Carb linkage pivot
Located in Los Angeles CA - asking $2000 OBO -
I see them listed on E-bay from $1600 - $3300 - if you're serious shoot me a message and we will figure something out.
The STR-15 was made by Edelbrock into the 70s and fit the low deck mopar big block engine (361/383/400) engine family.
Intake - all bolt holes appear good, no helicoils or oversize holes. The lid is the dual quad offet style. All surfaces seem clean and undamaged - no pitting or milling is apparent.
Carburetor linkage pivot is included -
Included: Intake base, Intake lid, Carb linkage pivot
Located in Los Angeles CA - asking $2000 OBO -
I see them listed on E-bay from $1600 - $3300 - if you're serious shoot me a message and we will figure something out.
