excited going to the dyno on saturday!

[Nokke]

Hey guys im going to the dyno on saturday any guestimates on hp?


1984 360block hughes main girdle, windage tray
Eagle 4340 4.000 inches crank
Eagle h-profile 6,125 rods
Srp pistons
compression 11,48
indy cylinder heads 210cc ported & polished flow intake 308 cfm exhaust 232 cfm
comp cams rx302s lift 654/655 & 0,50 duration 270/276 with my td 1,6 rockers 697/698
indy r3 intake port matched
holley 1050 dominator
tti 1 7/8 headers
msd distributor

 

[1 fst Dart]

I'll bite: 600-620

 

[viperredduster]

I am not sure prob not all that much, soooo I think we should trade engines and I can tell you what it will run in my ole red car! :toothy7:

 

[64physhy]

550-575 and 575-600 lb/ft

Mis-read the cam specs... More like 575-600 and 600-620

 

[flyfish]

617 hp with 532 ft lbs of torque.

 

[flyfish]

I assume you meant engine dyno right? If you meant chassis dyno then knock ~ 110 hp off my estimate.

 

[vtmopar]

Thats a beast
629 HP
506 ft lbs of torque

 

[Nokke]

yes thats right engine dyno i have a hope on a 6 something but you newer now

 

[vtmopar]

Whats the prize for the closest guess?:yawinkle:

 

[Nokke]

hey guys i am very happy 629,0 hp at 7100 rpm and 506,1 ft / lbs 5700 rpm im going to scan the dyno paper and show you guys and show you a video from the dyno

 

[64physhy]

That's some big power. I'm surprised the torque wasn't higher, though.
Flyfish was close.
Nice try vtMopar!