Firm feel k frame reinforcement

[Seandavid55]

Little windy for primer, so I'll clean it up a bit and hope it's calm tomorrow. Thanks for the help @72bluNblu. I don't think I'd of figured out those pieces.

All in all I don't think the kit was bad. Saves enough time that if I had another k member to do I'd buy it again. A sheet of paper in there for a little guidance would be great. Hell, draw a line and write "bend here" on the piece that gets bent.

 

[RustyRatRod]

Little windy for primer, so I'll clean it up a bit and hope it's calm tomorrow. Thanks for the help @72bluNblu. I don't think I'd of figured out those pieces.

All in all I don't think the kit was bad. Saves enough time that if I had another k member to do I'd buy it again. A sheet of paper in there for a little guidance would be great. Hell, draw a line and write "bend here" on the piece that gets bent.

View attachment 1715969874 View attachment 1715969875 View attachment 1715969876

Your welding looks good to me! Nice work!

 

[72bluNblu]

Little windy for primer, so I'll clean it up a bit and hope it's calm tomorrow. Thanks for the help @72bluNblu. I don't think I'd of figured out those pieces.

All in all I don't think the kit was bad. Saves enough time that if I had another k member to do I'd buy it again. A sheet of paper in there for a little guidance would be great. Hell, draw a line and write "bend here" on the piece that gets bent.

View attachment 1715969874 View attachment 1715969875 View attachment 1715969876

Looks good! Yeah the lack of any instructions or pictures that come with the kit kind of makes it a bit of of a jigsaw puzzle. It’s not terrible, but after I bought the first one I just make my own gussets. I made up some patterns using card stock and transfer those to metal. It really doesn’t take that long to make the pieces, the kit pieces need some fitting anyway.