ozmoparjoe
Well-Known Member
Hello all, I have a 4 speed, believe it's an OD, i have included some pics if you can tell me more about it that would be great. I had a mopar shop here (Melbourne Australia) set up a hydraulic clutch system for me as the original Z bar set up would be near impossible, being a right hand drive and all.
Now i screwed up the thread where the metal fluid line goes into the concentric throw out bearing housing which i have since learned is part of a Keisler kit, (see pic). So repairing the thread is proving to be difficult so i enquired with Silver Sport Transmissions to have a new one shipped out, but they no longer supply them.
Which brings me to 2 questions i have. 1: Is there a hydraulic throw out bearing that would be a direct replacement i could use? 2: If i decide to change to an external slave cylinder set up, would a Wilwood unit like the one in the pic work? I believe my master cyl is 5/8 bore.
Any advice would be greatly appreciated, thank you very much.
Now i screwed up the thread where the metal fluid line goes into the concentric throw out bearing housing which i have since learned is part of a Keisler kit, (see pic). So repairing the thread is proving to be difficult so i enquired with Silver Sport Transmissions to have a new one shipped out, but they no longer supply them.
Which brings me to 2 questions i have. 1: Is there a hydraulic throw out bearing that would be a direct replacement i could use? 2: If i decide to change to an external slave cylinder set up, would a Wilwood unit like the one in the pic work? I believe my master cyl is 5/8 bore.
Any advice would be greatly appreciated, thank you very much.