Headers with a 4 speed question.

[Relax360]

OK guys I have a question. What Headers are you using on a stock 4 speed? Customer with a 70 340 dart. Just wanted to know what combinations work? Or Custom headers?

Thanks

Brad

 

[philcollins]

TTI, 1971 340 W 4 speed. TTi Z bar

 

[Marcohotrod]

hooker 1 3/4" super comp

 

[72bluNblu]

Doug's d453's. I modified the z-bar per the TTI specs. '74 Duster with a 340.

 

[rustycowll69]

I have home made headers in my 64 340 dart 4spd. They fit pretty good. My buddy, Art Rasmussen and I drank about a case a beer, and stayed up all night about 40 years ago to make them.

 

[rklein383]

Here is the route I plan to go with my 408 in my 71 Barracuda. The majority will say to go with TTIs but I like these....
https://www.summitracing.com/parts/...dman-hedders&gclid=CMnewYj4ydMCFQMpaQod0uMIIQ

 

[72bluNblu]

Here's the modified z-bar info you need for either the TTI's or the Doug's. It's from TTI's website

Here's the one I did myself using an original. Basically you take the arm for the clutch adjuster, cut it off the Z-bar, slide it down to the very end of the z bar and reverse it so that the clutch adjuster stud faces inside instead of out and weld the arm back on. It's a pretty simple operation if you have a welder.

 

[Woodie]

hooker 1 3/4" super comp

Same here. Stock Z-Bar too

 

[72bluNblu]

Same here. Stock Z-Bar too

Not to mention a slip tube and header tubes below the steering link

 

[rustycowll69]

yeah, my homemade headers work with stock zbar, stock starter, manual stg box, and 70 340 aluminum bell housing. I do have one slip tube thru k-frame ears on the left side.