Heater blower motor firewall cover

[Demonx2]

I've looked through the forums on here but haven't found info on a cover plate to put where the blower motor sticks through the firewall (non-A/C 72 A-body). Does anyone make or sell a cover plate to install? I'll be installing a heater box later but for now, I'm just looking to install a cover plate over the hole. Anybody have info on one of these for purchase? I know AR Engineering sells one but thought I would see if anyone on here knows of others. Thx!

 

[CRUZE 418]

Make one?

 

[ChrisRomello]

I’m making one myself probably in the next week or two. I’ll post about it when I do.

 

[Demonx2]

Make one?

I don't have the right tools to make one I would want. Probably not the talent if I did have the tools either!! I figure somebody out there makes one that would be a lot better than any i would make.

 

[Demonx2]

I’m making one myself probably in the next week or two. I’ll post about it when I do.

 

[famous bob]

Yeah , a pairof tin snips , a file , and a piece of .062 alum. sheet is hard to come by !
Just dont forget to paint it before installing like I did .

 

[ChrisRomello]

Got mine done today!

I’m going to also use it as a mounting point for my Holley Sniper EFI Hyperspark Coil.