Help identifying intake

[RustyRatRod]

Father in law passed a few years ago and we are finally clearing his house out. He told me he had bought a 6pack intake for a slant 6 when he was in Australia, but I never saw it till now. Can't find much info on it and whether its worth selling or not. Any Info would be appreciated.

View attachment 1716481507

View attachment 1716481508

View attachment 1716481509

View attachment 1716481510

View attachment 1716481512

View attachment 1716481513

Yes, I hereby identify that as an intake. Those other things are exhaust manifolds. I accept Paypal. You're welcome. lol

 

[svracer]

It was initially done utilizing the rear half & outlet/heat-riser part of the OE manny, the front leg & runners were cut off, and a plate welded over the opening there. This way you could use all of the stock features, equipment, & heat to the intake. Dutra cast the front piece and voila, dual outlets, freer flow & the ability to tune the pipes for best torque/scavenging.

Ok I got it, so you would use the stock rear cut off from the front

 

[MidnightSwinger]

Ok I got it, so you would use the stock rear cut off from the front

Like so

 

[svracer]

Like so

View attachment 1716485872

Ok that helps, thanks

 

[Killer6]

Ok that helps, thanks

Mind You, if You're using an aftermarket intake w/o the heat riser well/pad to mate to & cover that part of the exh. manny, You'll need to fab a cover to bolt/weld on that. I believe Aussiespeed is making the Dutras now, if You wish to add the rear-specific unit to match the frt., as an intake like the Cain wouldn't use the choke well & riser etc.

 

[MadScientistMat]

I've just received a new batch of heat riser block off plates if you happen to need a pre-cut one.

 

[Hyper_pak]

Like this: