How To Hone Cylinders

[RustyRatRod]

RustyRatRod submitted a new Article:

How To Hone Cylinders

This is my method for honing cylinders with a ball hone, otherwise known as a dingleberry hone. This procedure is only recommended for cylinders with minimal wear, as it removes only a very, very small amount of material. Just enough to break the glaze cause by the polish of the rings going up...

Read more about this article here...

 

[RustyRatRod]

This article has been removed.

 

[340six]

This article has been removed.

Why?

 

[Illahe]

This article has been removed.

WTF?

 

[RustyRatRod]

Long story. Involved some legal crap. This will probably be the first one I will put back up. Bear with me.

 

[Princess Valiant]

This article has been removed.

 

[Illahe]

Long story. Involved some legal crap. This will probably be the first one I will put back up. Bear with me.

Ball hone or three stone?

 

[RustyRatRod]

Ball hone or three stone?

Just a ball hone.

 

[Workingdog1]

Long story. Involved some legal crap. This will probably be the first one I will put back up. Bear with me.

Bummer. I get the Legal Crap sometimes.
Print a pdf of text, change a word or two and no pictures ?
As Anthony Hopkins said in Legens of the Fall ?

Screw em !

 

[harrisonm]

Long story. Involved some legal crap. This will probably be the first one I will put back up. Bear with me.

Legal as in your instructions contained something that some company or person might object to, or legal in that the FABO staff might be afraid that somebody might do something wrong and hurt themself or damage their block???