Got my dart back from the top installer today.
What an ordeal, but the end result is wonderfull.
What an ordeal, but the end result is wonderfull.
I Don't Have To Go Topless Anymore!
- Thread starter Dana67Dart
- Start date
-
mopowers
Well-Known Member
Nice! What's that white stuff on the ground?
Looks nice, they did a good job.
Left over snow from Feb.
jbc426
Well-Known Member
Looks nice and wrinkle free. How are your seals working. I have to roll my windows up after the top is up & latched, so they seals work better. Does your car have that issue?
This kind of work is beyond my capabilities, and I had to pay to have mine installed too. How much was the install?
This kind of work is beyond my capabilities, and I had to pay to have mine installed too. How much was the install?
TrailBeast
AKA Mopars4us on Youtube
Oh yea.
Not as good as I would have liked. The front header sesl to A Piller seal (windshield) has a huge gap at the joint between them. A Piller is from 67 so that might be part of the issue.
No problem with glass to weatherstripping, I seem to recall that you are supposed to roll all windows down a tad put top up then roll windows up.
I even fixed my driver's side glass top alignment by replacing the wind wing plastic slides, and adjusting the frame a tad
Last edited:
I'm a bit of a perfectionist and see every little flaw. But now I know what NOT to do if I do it again. I'll do a post on the adventure in the weeks to come.
No one noticed the rear glass and how it follows the body line....
Top company made custom curtain with my oe glass! Not much more expensive than their standard glass.
It can be done!
-
