Intake

[Mopar Al]

I have a 360 totally done but want to go to a tunnel ram. Problem is that whei I had the motor built there was a problem with the intake fitting, aparently the deck height was never checked and the intake had to be milled. Question is can I take the milled intake ank T ram to the machine shop, or do I need to take the motor?

 

[70aarcuda]

set the intake manifold on the head with no intake gasket...do the hole line up?

are they above or below the intake bolt holes?

you can use the thickness of the intake gasket as a guide .....

I dont like to mill intake manifold...i rather mill the intake face of the heads......cause once you cut that intake manifold it only fits that combination....