Thanks for the update 1969383S. Kim
You can as a complete unit.
But if you change components of it (the pumpkin) you may have issues. 742 cases used a Dana 4 spider center. The 489 used the Cone type center. The over all diameter of each is different. Never had an issue with 4.56 and the small pinion but when changing to 3.55 I got pinion rub on the cone center when trying to achieve gear pattern in the 742 case.
Please cause I'm drawing a Blank!I will find the thread to remind you.
Please cause I'm drawing a Blank!
Oh yeah, I remember now. Sucks getting old! To date I have not encountered this, I hope I never do. But if it did I would turn the SG case down. How did the set up work out in the long run?
Oh yeah, I remember now. Sucks getting old! To date I have not encountered this, I hope I never do. But if it did I would turn the SG case down. How did the set up work out in the long run?
Man I'm jealous, I've always wanted to go there.Just fine! I would have turned the case but did not want to redo the carrier bearings again.
Just returned from a little cruise! Going to load it in the trailer on the 4th as we are leaving to Carlisle the following Wednesday. Never been there and looking forward to it!
This only happens when you install 3.55 gears in a 742 case with a Borg Warner cone sure-grip. The pinion head is just thick enough and the outside diameter of the sure-grip is just large enough to collide.