Kickdown Carb Rod

[VOETOM]

One angle

 

[ratty dart 340]

For sure the Holley bracket is needed and you may have to raise the manifold bracket to allow for the extra height caused by the Air Gap. We run the same setup on my brother in laws car and in fact, one of the images in my book is it.

Here is the four barrel lever and the two barrel lever and the only rods I have left

View attachment 1716234248

Hmm, interesting.

 

[ratty dart 340]

One angle

View attachment 1716234251

Is that rod the same as one of the rods you sent in the other image?

 

[VOETOM]

Poor weld job but it was hurried; you can see how much was added to fit the spacer and the Air Gap.

 

[ratty dart 340]

Poor weld job but it was hurried; you can see how much was added to fit the spacer and the Air Gap.

View attachment 1716234256

Mine looks damn near identical with similar weld.

 

[VOETOM]

May be the same kind of rod. We modified a 2 barrel one to work with the 340 bracket and the other two barrel parts we had.

 

[VOETOM]

Here is a shot of AAs 340 setup. It is dead right on.

 

[ratty dart 340]

Here is a shot of AAs 340 setup. It is dead right on.

View attachment 1716234264

Wow. I just need to find pressure rod and should be smooth sailing. I am kind of surprised there aren't more aftermarket options. Probably because it is such a specific part.

 

[VOETOM]

Please check that bottom lever to be sure it is the short one. The long one will cause you lots of issues unless you redrill it.