Kwik Wire setup

[Wes]

Thought I could post this to clear up some of my questions and be a guide for the electrically challenged like myself. Keep in mind, I'm running an MSD Ready to Run Distributor that does not require a ballast resistoror ignition module.

Wire White #14
From Fuse panel, splits to Volt Reg and Field side Alternator?

Wire Red #15
From Fuse panel, splits to Volt Reg and BAT side of Alternator?

Wire Red #16 contains the Maxi fuse
From Fuse panel,direct to Bat side of the relay. From relay to the Bat side of starter?

Wire Purple #19
From ignition switch to Neutral Safety Switch, then to start lug on alternator.

Wire Pink #20
From Fuse panel, splits to relay and to Coil (+)

Can someone verify?

Thanks,
Wes

 

[Wes]

Nevermind

If anyone using this setup would like to PM me, I can send you a diagram I'm drawing up.