Largest Slant Six Flywheel

[RustyRatRod]

What is the largest diameter slant six flywheel I can use with the overdrive bellhousing? 10.5"? Also with the stock 64 three speed bellhousing? Thank you drive through.

 

[Garrett Ellison]

Here is a little information from brewers performance, I hope it's relevant to your casting numbers. I'll dig a little deeper and see what I come up with.
Brewer's Performance - Mopar A833 4-Speed Transmission and Component Specialists

 

[Garrett Ellison]

And delivering as promised, a good read about the 10 inch HD clutch for the 122 tooth \6 flywheel. sl6-clutchs

 

[kesteb]

This is probably better the either of the above: Slant 6 10" Performance Clutch Install 3-16-12 - Slant Six Forum

 

[RustyRatRod]

Thanks yall! That helps a lot but dammit, that's an expensive flywheel. It figures.

 

[Hyper_pak]

I had Mcleod make me a 10.5 steel flywheel with a slant flange years ago. I think its a standard part for them now. Ran a Green cover Hemi disk and plate with my 4 speed for years. No more smoked clutches. Had a custom adaptor with a 340 Lakewood and tilton starter. This picture is with the direct drive starter, that didn't work. Not cheap.