Bennoel 10
Well-Known Member
Yes it is. It's just a reverse look as it's located on the contour of the inner trunk lid.
Looking for a template for cutting out the underneath side of a trunk lid of a duster for a wing mounting support
- Thread starter flathead31coupe
- Start date
-
flathead31coupe
Well-Known Member
Ok ty
Bennoel 10
Well-Known Member
Welcome
flathead, how did you do? did you get the holes cut?
i have a 73 Duster and i am trying to add the gull wing from first place auto but they are on back order everywhere, i need to cut the hole also, i was hopeing to buy the template some where but having no luck..Rich
i have a 73 Duster and i am trying to add the gull wing from first place auto but they are on back order everywhere, i need to cut the hole also, i was hopeing to buy the template some where but having no luck..Rich
flathead31coupe
Well-Known Member
I have not cut the hose yet. I got the pictures with measurements from a fellow member on here. The problem I have is when I got the car somebody had already installed the wing and they were off with the measurements about an inch or so coming down the deck lid so it throws the mounting underneath off. I have to address that.
-
