[SOLD] Lower control arm Pivot pins

-
Status
Not open for further replies.
You left out a lot of important information.

Are they A body, or B & E, Body?

They are different between the body styles.
 
69413valiant said:
Been sand blasted up. In great shape. $22.00 shipped
Click to expand...

I'm not sure I would have sandblasted them; I would think soaking them in Evaporust might have been better. If you removed the inner shell, they might sell quicker.

hemi71x said:
You left out a lot of important information.

Are they A body, or B & E, Body?

They are different between the body styles.
Click to expand...

Jim - Just out of curiosity what is the difference between the 3? I figure the length of the pivot.
 
65 Dartman said:
I'm not sure I would have sandblasted them; I would think soaking them in Evaporust might have been better. If you removed the inner shell, they might sell quicker.



Jim - Just out of curiosity what is the difference between the 3? I figure the length of the pivot.
Click to expand...

Correct.
Length's of the pivot pins, (shafts) are different between A's, and then B's & E's. B & E's are the same, and are interchangeable.
Plus the outer diameters are different. Larger & smaller.

I doub't bead cleaning, (sandblasting) has any ill effects to the pins.
It's not going to hurt them.
I use Evaporust, or just clean them up with the wire wheel brush, on the bench grinder.
Not building a space shuttle, rocket ship, here.
 
someone may want to put poly bushings on them in which case the removal of inner sleeve would hinder sale.also i took one look and knew they were a body...b and e the step down on k frame side is further out than the a.
 
Status
Not open for further replies.
-

Back
Top