I'm going to put a 727 with a manual valve body with a B+M ratchet shifter. Do I have to do anything with the kick down linkage or do I just leave it off I've read that the kick down circuit is important to the 727 trans. So what do I need to do? Jim
manual vale body question
- Thread starter sorewrist1
- Start date
-
Throw it in the ditch.
depends on the manual valve body.... the ones made by a Trans go kit will need the lever tied back at full pressure...
if the manual vavle body is from a trans company like Turbo action...CRT or who ever...then there will be no need for the KD linkage....
if the manual vavle body is from a trans company like Turbo action...CRT or who ever...then there will be no need for the KD linkage....
Very funny Rob . Are you saying throw the tranny in the ditch. or the manual valve body in the ditch. or the B+M shifter in the ditch?
The kickdown linkage. But Tony's right. The lever on the transmission may need to be tied back depending on the V/B, but you won't need the linkage anymore.
Good Will have to check trans Thanks guy's Jim
-
