[SOLD] Megasquirt 3 Hemi Gen III

[Joe Dokes]

I built this Megasquirt 3 controller to use as an engine control module for a Gen III Hemi.

The kit was bought from DIY Autotune. I assembled and and tested the unit myself.

I purchased the following kits:

Megasquirt 3 $385.00
MS3X Expansion card $105.00
JimStim X expansion $ 44.00
JimStim $ 59.00
Bip373 8x$8.50. $ 68.00

Total. $ 661.00

Your price $400.00

The kit includes the ecm plus expansion board which will allow you to control fuel and spark for a Gen III Hemi, though if you added a tone ring it could be used on any engine. The Jim Stims allow you to test the Megasquirt Ecm.

Your price: $400.00 + shipping + 3% PayPal fee. Of course local pickup with cash mean no extra fees.

 

[dartboy73]

Joe your inbox is full but is this all I would need to get my 6.1 running? Would I need a wire harness?

 

[Joe Dokes]

Sorry about the inbox. I'll take care of it.

Yes you'll need to make a harness and or buy one. Here's a couple of links to help you figure out what you need.

How to MegaSquirt Your Chrysler Hemi Engine - DIYAutoTune.com

10' MegaSquirt Wiring Harness for MS3X

10' MegaSquirt Electronic Fuel Injection Wiring Harness (MS1 / MS2 / MS3 Read

You'll also need to set your car up for fuel injection and replace the factory drive by wire throttle body with a cable operated throttle body.

Hope this helps.

Joe Dokes

 

[Joe Dokes]

Here's a thread where a member used Megasquirt on his Gen III Hemi.

How to Megasquirt your 3G Hemi

Regards,

Joe Dokes