[SOLD] Misc. Performance Parts

[Locomotion]

All parts include shipping within the 48 states.

* 5 gal. aluminum fuel cell w/foam. Pair of #10 outlets and #8 return & vent w/checkball. NEW - May be Summit brand. 12'x12'x8" - $135.00

* Bronze distributor/oil pump drive for small block - Mopar P3690874. New - installed in engine but never run & removed. - $160.00

* Mopar coil P3690560 New, never used - $45.00

* 1350 billet steel yoke for 8 3/4"rear - course spline. Used but in VG condition.
Needs u-bolts. - $110.00

* U-joint strap kit Mopar P3690774. NEW - (Services u-joint conversion kit P4120714AB & for 1330 yoke.) - $6.00

* U-joint strap kit Mopar P4120469. NEW for 7290 u-joints - $17.00

* Piston rings - Childa & Albert Dura-Moly file fit. 5/64"-5/64"-3/16" low tension oil.
--RS-10477-025 (4.020" bore) - $90.00
--RS-10477-045 (4.040" bore) - $90.00

* Holley adjustable vacuum pod assembly & springs For 4160 carbs. - $25.00*****SALE PENDING*****

* Milodon valve cover breather 85682. NEW - $10.00

* Pioneer valve stem seals - 16 3/8" stem, .500" OD guide - teflon, positive stop. - $15.00

 

[Locomotion]

Trailer accessories:

Pit Pal #330 Helmet shelf/uniform hanger - $40.00

Pit Pal # 217 Tie-down strap holders - 2/$15.00

Cargo Pal spark plug holder - $5.00

All prices + shipping from 32117 in Florida.

 

[Locomotion]

Comp Cams springs, retainers and locks.
All new, never used. A few items assembled, then disassembled.

* 926-16 single springs - 2 sets
- 109 lbs @ 1.800"
- 317 lbs @ 1.300"
- Spring rate - 415 lbs/in
- Coil bind - 1.140"
- $75.00 each set

* 740-16 steel retainers - 2 sets
- 1.437" O.D.
- .690" I.D.
- $47.00 each set

* 26120-16 beehive springs - 3 sets
- 155 lbs @ 1.880"
- 377 lbs @ 1.280"
- Spring rate - 370 lbs/in
- Coil bind - 1.230"
- $185.00 each set

* 26918 - 16 beehive springs 2 sets
- 125 lbs @ 1.800"
- 367 lbs @ 1.150"
- Spring rate - 373 lbs/in
- Coil bind - 1.100"
- $170.00 each set

* 795-16 steel retainers 2 sets
- 1.095" O.D.
- .640 I.D.
- $47.00 each set

* 616-16 10* Super Locks 2 sets
- + .050"
- 3/8" single groove
- $18.00 each set

* 623-16 locks 2 sets
- standard height
- 8mm single groove
- $28.00 each set

* Moroso 62540 solid steel motor mounts used
- A-body '67 - '72
- $20.00 for the pair

All prices + shipping from 32117 in Florida.

 

[Locomotion]

Weiand Stealth small block intake manifolds.
Good condition, no stripped or repaired threads.
$120.00 ea. + shipping from 32117

Fan spacers Lengths as noted.
$10.00 each + shipping from 32117


*****************************************************

ITEMS SOLD

* 5 gal. aluminum fuel cell
* Holley adjustable vacuum pod & springs
* 1 set each of Comp Cams 926-16 single springs, 740-16 steel retainers & 616-16 10* Super Locks. (Still have 1 set of each.)
* Bronze distributor/oil pump
* Pit Pal #330 Helmet shelf/uniform hanger
* Pit Pal # 217 Tie-down strap holders

 

[Demonracer]

Myron,

What is the centerline measurement on the mounting tabs of the fuel cell, and are they the same on both sides?

Thanks,

Bill S.

 

[Locomotion]

Bill,

Unfortunately I can't take a measurement because the fuel cell is boxed up and ready to ship after work today. Since the forum doesn't allow editing ads after a short period of time, I had to post a list of parts already sold which is just before your post. Sorry I couldn't indicate it as "sold" in the original post.

There was a note attached to the cell that says the tabs are not suppose to be used for mounting, just "locating" and that straps should be added. Probably a good idea since it would secure it better. But I haven't gotten around to doing it on the cell in my car.