Mopar 398 Cubic Inch Short Block **X BLOCK**

[KRYPTONITE1972]

I have a 398 Cubic Inch Short Block,
Fresh Complete Short Block, *****SHORT BLOCK ONLY****

Aftermarket X Block
Ross Forged Pistons
Corillo Rods
Cailies Crank
Solid Roller 630 Lift 260 Duration

$3800 ****OBO***

Located in Charleston South Carolina

 

[KRYPTONITE1972]

*****************$3500 obo**************************

 

[345man2]

how did the motor run when it was together?

 

[KRYPTONITE1972]

Never ran it, when I got the Motor it was Running Low 6's in the eigth With W2 heads, in a Duster. I Have not been able to run it since I got it and Freshin it up, I bought a set of W9 heads for it and needed to change pistons in the motor, but never got to it yet and Now selling it all

 

[KRYPTONITE1972]

4.03 bore 3.9 stroke 398 Cu in

 

[345man2]

what compression pistons are in it and is the cam new, and just to check is it a fresh rebuild?

 

[345man2]

what heads were on it when it ran those times?

 

[KRYPTONITE1972]

fresh Rebuild, Cam is the Same, they were a Set of W2 heads on the motor, Not sure the Compression on it,
Thanks

 

[345man2]

thanks for the info are they flat top or dome?

 

[KRYPTONITE1972]

little Dome to them

 

[wolverinedave]

What is the connecting rod length/manufacturer and piston c/d. wrist pin dia. Cam drive, I would like to talk to you about this short block.

 

[wolverinedave]

I'm interested in buying your short block.

 

[KRYPTONITE1972]

What is the connecting rod length/manufacturer and piston c/d. wrist pin dia. Cam drive, I would like to talk to you about this short block.

Ok sounds Good

 

[KRYPTONITE1972]

Nobody is looking for a Bad A$$ motor for there Ride????? I can Believe this is still in my shop!!

 

[KRYPTONITE1972]

SOLD SOLD SOLD Thanks Abodiesonly

 

[105cuda]

do you still have the dakota roller?