Does anyone know if there are any commercially made gaskets available or if you just have to cut your own?
Thanks,
Tom
Thanks,
Tom
Mopar M1 Tunnel Ram Base to Plenum Gasket
- Thread starter PROSTOCKTOM
- Start date
-
I just welded my top to my runners, never need gaskets again. Honestly I think if you took a bastard cut file to both surfaces and used epoxy you could solve the gasket problem.
That's not going to happen on this intake.
Worst case I'll draw it out in CAD and have them cut, but would rather just buy them if available.
Tom
Worst case I'll draw it out in CAD and have them cut, but would rather just buy them if available.
Tom
I believe Superformance gaskets has them. I know they did at one time.
I know they still have W2 gaskets.
I know they still have W2 gaskets.
Thanks, just looked at their website. Part #4005
$29 at most retailers.
That will save me a lot of time and effort.
Tom
Last edited:
-
