billshotrod
Well-Known Member
Aluminum Small Block Bell housing For Sale.
Aluminum bell housing for 69-71 small block to a833 for sale. I have misc clutch linkage to go with it. I also have a z bar that needs some repair. I would like to get $120 for the bell housing, zbar and clutch linkage. Parts are located in Old Saybrook, CT
Good running 318 for sale.
It was pulled out of a 1972 dodge dart about 4 months ago. The motor has good compression in all eight cylinders. It did not smoke when it ran. The cam has been upgraded to a Lunati Voodoo cam. The cam was broken in properly following lunatis directions. It also has a 1970 340 four barrel intake manifold topped with a 600cfm Edelbrock carburetor. The motor includes pulleys, alternator and bracket. I am looking to get $550 for the motor. The motor is located in Old Saybrook, CT.
8 ¾ Center Section For Sale
4.30 sure-grip 489 center section available for sale. It was built by Randy J out of Connecticut. It has very low mileage on it. It has a crush collar delete installed on it. It also has a big u-joint setup. It is built for a Street/Strip application.
I would like to get $600 for it. It is located in Old Saybrook, CT
Thanks Bill
Aluminum bell housing for 69-71 small block to a833 for sale. I have misc clutch linkage to go with it. I also have a z bar that needs some repair. I would like to get $120 for the bell housing, zbar and clutch linkage. Parts are located in Old Saybrook, CT
Good running 318 for sale.
It was pulled out of a 1972 dodge dart about 4 months ago. The motor has good compression in all eight cylinders. It did not smoke when it ran. The cam has been upgraded to a Lunati Voodoo cam. The cam was broken in properly following lunatis directions. It also has a 1970 340 four barrel intake manifold topped with a 600cfm Edelbrock carburetor. The motor includes pulleys, alternator and bracket. I am looking to get $550 for the motor. The motor is located in Old Saybrook, CT.
8 ¾ Center Section For Sale
4.30 sure-grip 489 center section available for sale. It was built by Randy J out of Connecticut. It has very low mileage on it. It has a crush collar delete installed on it. It also has a big u-joint setup. It is built for a Street/Strip application.
I would like to get $600 for it. It is located in Old Saybrook, CT
Thanks Bill
