AR_Tech
Well-Known Member
Contact seller
These are Procomp heads (Edelbrock knock off heads/was told they are better castings than Edelbrock by MRL). They are off a 360 that I built. They have less than 5 hous run time on them. I am going a different direction, and I don't need them anymore.Heads have dual spings for a solid roller cam. Has a "stage 1 port job". Paperwork for the heads have 225# seat and 50# open. Coil Bind @760" Lift, Retainer to Seal Clearance is .765". Would like to get $1600 OBO, plus shipping cost. Heads just got milled the bare minimum to slick them back up. I measured the chambers to be 65-66 cc. I am located in central Arkansas.