Rodsaknockin
Well-Known Member
I was wondering if anyone is using the msd e curve distributor in there small block and if so how is for setting and adjustments ? Thanks in advance
Msd e curve distributor
- Thread starter Rodsaknockin
- Start date
-
They work well. Set the dip switches up and go with it.
Rodsaknockin
Well-Known Member
Thanks for the info was looking online here and there seen a few mixed feelings I might try it or a pertronix
I know it's an old thread, but Thank You, Crackedback. I bought one of these 10 years ago for my build I'm finally performing. I got it at a good price back then. I've recently pulled all the parts out that I've rat holes for 13 years. Now retired, I'm putting all this stuff into my now being built 408 for my 1970 Swinger 340. The original motor is shrink wrapped in the corner of the garage, in case I restore it to build sheet condition. I want to run this old girl without worrying about losing money if I throw a rod through the original numbers motor.
-
