[FOR SALE] Narrowed 8.75 housing & parts

[RockinRobin]

Was a B Body housing.
$400 plus shipping from 78642, or best offer.
Internals are Moser 35 spline axles and Moser spool.
Moser yoke for large size U-joint.
Stiffener bar welded to the back.
About 150 passes on this setup.
Needs new ring and pinion gears.
Measurements:
Housing flange to housing flange: 46 1/4"
Axle flange to axle flange: 51 1/4"
Perches center to center: 28", 3 degree downward pinion angle.
Axles are large brake drum hole, 5x5 pattern, extra holes for 5x5 1/2 pattern.

 

[Dartn440]

Odd bolt pattern for Mopar. Is it 5 x4 1/2 or was it set up for something else?

 

[RockinRobin]

Odd bolt pattern for Mopar. Is it 5 x4 1/2 or was it set up for something else?

5x5x1/2. Set up is for drag racing.

 

[hidden_threat]

What was this rear in? I'm curious how close to an Abody measurement it is?
Thanks
Dave

 

[RockinRobin]

What was this rear in? I'm curious how close to an Abody measurement it is?
Thanks
Dave

It was in the red Duster bracket car that you see in the picture under my name.
It is set up for a narrowed A body.

 

[hidden_threat]

It was in the red Duster bracket car that you see in the picture under my name.
It is set up for a narrowed A body.

For springs moved in on the frame?
Thanks
Dave

 

[RockinRobin]

For springs moved in on the frame?
Thanks
Dave

Yeah, Dave, the springs have been inboarded quite a bit, I'd say about 6" per side for a total of 12", but if you install your own spring perches you can put them wherever you want.