growdude
Disabled but not dead
Anyone have measurements for upper and lower 4 link bars and size of tubing.I'm using a Dana 60.I'm trying to fabricate as much as possible my self.any help would be greatly appreciated. thanks
need help building my own triangulated 4 link for my 70 dart
- Thread starter growdude
- Start date
-
Riddler
Project EH-Body
Here read this.
http://www.forabodiesonly.com/mopar/showthread.php?t=101437&highlight=link
Most of the measurements can be found here as well as whats needed. Also you might need custom measurements when you build it yourself.
You could always just buy the RMS Street Link setup and be done with it. Once you figure everything out and then buy the materials and time you might just be ahead buying a kit and installing it.
Good luck either way you choose to go.
Riddler
http://www.forabodiesonly.com/mopar/showthread.php?t=101437&highlight=link
Most of the measurements can be found here as well as whats needed. Also you might need custom measurements when you build it yourself.
You could always just buy the RMS Street Link setup and be done with it. Once you figure everything out and then buy the materials and time you might just be ahead buying a kit and installing it.
Good luck either way you choose to go.
Riddler
-
