Need Help with Rubber bumper kit for my 69 Barracuda

[Mike69barracuda]

I bought from Dale's cuda shop this bumper kit and don't know where all these go. If you can help that would be great. My car just came out of paint some of these were never on the car. Any of these go on the Doors or doorjambs and what about the trunk lid?? I placed the 4 big rubbers under my hood in the fender holes. Iassume the very small pointy ones are for the glovebox.

 

[halfafish]

Wow. That's one nice looking fish!

I can help with a couple of these. The round one in the lower right corner along with the one above it are hood bumpers. The hole goes around the screw at the front of the car, where the hood closes. They adjust to make the hood line up right. You are correct, the tiny ones are glovebox. And maybe a console door if you have one? For sure, two of the four roughly D-shaped ones directly above the "Quicksilver" are hood bumpers. They go back close to the hinges, and I suspect the other two are the same thing for the trunk. I have a 69 FSM, I'll take a look to see if I can figure out the others.

 

[Professor Fate]

Top left I believe is for the console lid, to the right is ash tray door, others are as halfafish said. Not sure about the 4 on bottom left, but they do look like the door bumpers on my Dart...

 

[Cuda Al]

Two upper left - License Plate
Four lower left - Door
Two upper right - Trunk
Two lower right - Hood
Four lower middle - Hood
Two left upper middle - Ash Tray
Two right upper middle - Glovebox


Alan

 

[Mike69barracuda]

THX everyone. Big help to me.