I am trying to determine the position of my t/y block (its not really a t or a y) anyway, how does it mount on the 8 3/4 rear housing. I am going to weld a bracket but want to get it some what looking like it should position wise. (if that is possible) lol
need pic of brake t block on the duster 8 3/4
- Thread starter Dustedu2
- Start date
-
Riddler
Project EH-Body
Mine was mounted with the vent. The vent screws into the housing and holds the T/Y on.
Riddler
Riddler
Yeah, but I am mounting it to my Dana 60 and want to weld a bolt to the housing but I would like to make it look similar to that setup. I want to see which angle the tubes go to each side of the rear end. Hope that makes sense.
The rear I just took out was custom job to so can't compare to that. -
