[SOLD] NOS Mopar Performance Mushroom Tappets!!!

[metallidart]

I have some never used, original Mopar Performance mushroom solid lifter that I will never use, pn P3690137. I just got them this past weekend, and at the moment I only have 15. The guy I bought them from said the box they were in had spilled and he must have missed one, he won't be back up to the garage until this weekend, at which time he will find it and drop it off to me.
Mopar discontinued these, so grab them while you still can. They used to run about $15 each, but I will make whoever a killer deal. According to my research, they will fit small blocks, big blocks, and Hemi engines.

--buy the lot of 15 for $80 shipped now, and I will send you the last lifter for free when I get it. I hope he can find it, but you will only be paying for 15 of them. I can't promise I will get it, but I know the guy and I don't see why he would lie.

--OR, if I don't have a buyer before I get the last lifter, once I have a full set it will be $100 shipped.

Either way, these are a good deal! They are located in East Palestine, OH 44413. Send me a pm! By the way, the shipping is free in the lower 48. Thanks!

 

[66fs]

I'll take them when you have 16. Thanks

 

[metallidart]

Ok, cool! I'll send you a pm when he delivers. Hopefully monday. Thanks!

 

[metallidart]

Gonna call him today to see if he was able to get the last one!

 

[superdart426]

2nd in line for 16

 

[metallidart]

I keep forgetting to call the guy! Grrr...

 

[pishta]

What do you use these on, a custom ground cam that would utilize a larger base circle?

 

[robertob]

What do you use these on, a custom ground cam that would utilize a larger base circle?

Custom ground cam with a higher rate of lift, assuming your heads can use the increased velocity.

 

[henry b]

fyi don't forget these lifter have to be installed from the bottom of the lifter bores before the cam is installed .

 

[RustyRatRod]

What do you use these on, a custom ground cam that would utilize a larger base circle?

Mushroom lifters on a mushroom cam. They were the forerunners to rollers.

 

[pishta]

fyi don't forget these lifter have to be installed from the bottom of the lifter bores before the cam is installed .

Learned that on my '57 Ford 312, same dealy-o. Long Magnetic pick up tool and 16 laundry clips!

 

[metallidart]

If he can't find the last one, its going to bum me out. I never thought of clips to hold them up somehow!

 

[RustyRatRod]

If he can't find the last one, its going to bum me out. I never thought of clips to hold them up somehow!

Large clothespins work well. Or you can simply install the cam with the engine upside down.

 

[66fs]

...simply install the cam with the engine upside down.

Yup, and I have a 273 block already cut for them...

 

[pishta]

...... Or you can simply install the cam with the engine upside down.

Yes , that makes for a rather busy cam swap.

 

[metallidart]

I just called him, and he said he hasn't been up to his garage, actually his dads garage, yet. He is supposed to go up this saturday, and he said he would get ahold of me sometime saturday.
I just dug the pic out of the parts, and it looks like he did have 16 lifters lol.

 

[metallidart]

Sold!