Panel Replacement

[muddacres]

I'm replacing a rear quarter panel on my 70 swinger. I was just wondering how you guys do your spot welds? I'm thinking of drilling a 1/8 " hole and weld through that.
Thanks
Jim

 

[doug 371]

1/4 is better or 3/16

 

[dusterny]

Why not try one of the spotweld removal bits? I have seen them in car mags not too much money.

 

[oneway71]

I use a punch where I can; and a varibit in the other spots. 1/8 or quarter would work. My punch is an 1/8th. works well.

 

[green1]

Harbor freight has them in local stores. $5, and awesome, and lasts. You can even turn it over to expose new bit.

 

[muddacres]

I'm sorry, I wasn't very clear. I already removed the quarter and I'm replacing it. I tried lots of spotweld cutters and I found that Blair had the best one. Here is there website. Blair Spotweld Cutters
Jim