Partial engine VIN

[Señor Ding Dong]

Hey all, I’m sorry, I’m sure this has been asked and answered, but I can’t find it.

My 1966 Dart has a 318 swapped into it by a previous owner. With the casting numbers I’m able to pin down all the casting and assembly dates, etc, I know it’s a 1971 318, it appears with the original intake, carb, and manifolds. I’m not sure about the transmission or rear and, just that it’s a 904 tranny, and an 8.75 limited slip rear end. My question is, can I track down what type of vehicle it came out of, based on the partial VIN on the block? 1G127748. All I know is that it confirms that it’s a 71, and the car/truck was built in St Louis. Is there any other info about model or anything to be found?


Thank you!

 

[33IMP]

Not really from that, other than finding out what line of cars were built in St Louis in 71. 318 could probably be found in everything they built.

 

[Señor Ding Dong]

Is there any way at all to tell what vehicle an engine came from? From any of the numbers, or anything at all? Not that it really matters, I just want to have as much information about my car as I can.
The numbers I’ve pulled so far:
Engine casting:2536030-4

67-74 318

Date Casting:2/4/69 day shift

Stamped front drivers side: GM318R 3359 0063

1971, Mound Rd, 318 Regular fuel, Dec 1, 1969 assembly, #63 that day

Stamped bottom pass. Side: 1G127748
1971, St Louis Assembly

Intake casting: 2951185
1970-71 2bbl

Transmission drivers side: 05305
77 with a bunch of squares after it

Rear end - 8.75

2881489 (tapered pinion shaft, 1969 to about 1974)

Have I missed anything from those numbers?